Summary of Offer for an Embedded Licence

With the conditions of use specified above, an embedded licence entitles the holder to receive the following software:

1. The kernel of GKSGRAL and GKSGRAL-3D at the current revision level in object-code format for one of the following operating systems: MVS, VM/CMS, VMS, AEGIS, UNIX or SINTRAN-3.

2. The drivers available at CERN in both object-code and source-code format.

   As of January 1989, CERN holds licences to distribute the following drivers for use on the systems listed in parentheses:

   • TEKTRONIX 4014 (MVS, VM/CMS, VMS, AEGIS, UNIX, SINTRAN-3)
   • TEKTRONIX 4107/4109 (MVS, VM/CMS, VMS, AEGIS, UNIX, SINTRAN-3)
   • TEKTRONIX 4235/6 (VMS) =3D driver= (in preparation)
   • Hewlett-Packard Plotters (MVS, VM/CMS, VMS, AEGIS, UNIX, SINTRAN-3)
   • VERSATEC Plotters via VERSAPLOT (MVS, VM/CMS, VMS, AEGIS, UNIX, SINTRAN-3)
   • PERICOM MG600 (VM/CMS, UNIX, VMS)
   • PERICOM MX2000/7000/8000 (VM/CMS, UNIX, VMS)
   • VAXstation (VMS-UIS)
   • APOLLO GSR and GSR (AEGIS/UNIX)
   • MEGATEK 33xx (VMS) =3D driver=
   • PostScript (VM/CMS, VMS, AEGIS, UNIX)
   • QMS LG(VMS)
   • VT240 and VT340 (VMS)
   • XEROX printers via EPIC (VM/CMS)
   • IBM APA 6670 and 3812
3. The skeleton drivers in source-code format.
4. The source-code of the link routines necessary to re-configure the system with extra drivers.

CERN is entitled to distribute updates and additional drivers to institutes holding such a licence. However, additional software not available at CERN, may be purchased directly from GTS-GRAL with the following conditions:

1. A 35 other than those already licenced at CERN.
2. A 50 for drivers not already licenced at CERN.

A current list of products available from GTS-GRAL may be obtained by writing to the address given below. Over 50 computers are supported and a similar number of drivers exist.